Arturo PU2035
Arturo PU2035 Self-smoothing Floor is a solvent-free, 2-component, aromatic polyurethane-based floor finish. Arturo PU2035 Self-smoothing Floor is tested according to AgBB and is ideally suited for interior use.
Applications
It is suitable as a coloured, durable and seamless finish for cement and anhydrite bound subfloors. Arturo PU2035 is especially suitable as a finish on floors that are exposed to light loads, for example for:
- Museums and showrooms
- Offices
- Schools / Kindergartens
- Shops
- Private homes
Properties
- Seamless
- Easy to clean
- Impermeable to liquids
- Permanently elastic
- Self-smoothing
- Crack bridging
- Increase walking comfort
- Emicode EC1 PLUS
| Consumption |
Approx. 1.57 kg/m²/mm layer thickness |
|---|---|
| Mixing ratio |
86.0 part by weight comp. A |
| Full mechanical resilience |
After 3 days* |
| Water and chemically resistant |
After 7 days* |
| Layer thickness |
Approx. 2 mm |
| Solids content |
100% |
| Shore-D (7d/21°C/60% r.h.) |
Approx. 30 |
| Tensile strength (7d/21°C/60% r.h.) |
approx. 8 N/mm² |
| Article number | Article | Packsize |
|---|---|---|
| Multiple colours | Arturo PU2035 10 kg | Set: A + B = 10 kg: A = 8.60 kg, B = 1.40 kg |
| Multiple colours | Arturo PU2035 25 kg | Set: A + B = 25 kg: A = 21.50 kg B = 3.50 kg |
| Multiple colours | Arturo PU2035 5 kg | Set: A + B = 5 kg: A = 4.30 kg, B = 0.70 kg |
Frequently Asked Questions
Arturo PU2035 is a two-component, self-smoothing polyurethane resin floor for interior areas exposed to light loads. Typical applications include offices, schools, museums, showrooms, shops and private homes. It provides a seamless, easy-to-clean finish with permanent elasticity for increased walking comfort. It is not intended as a heavy-duty industrial flooring finish.
Arturo PU2035 is permanently elastic and has tested static crack-bridging properties. However, this does not replace proper substrate preparation or assessment of cracks and movement joints. Prolonged heavy static loads can also leave indentations, so consider furniture and equipment loads when specifying the floor.
PU2035 is suitable for correctly prepared cement- and anhydrite-bound subfloors. The substrate must be sound, load-bearing and free from grease, oil, loose material and contaminants that could affect adhesion. Mechanically prepare the surface, vacuum thoroughly and repair defects before application. Substrate moisture must be below 75% relative humidity, using the appropriate test method.
Mix 86 parts component A with 14 parts component B by weight. Stir component A thoroughly, add component B and mix for at least two minutes using an electric mixer at approximately 300–400 rpm. Transfer to a clean container and mix again for one minute. Pot life is approximately 30 minutes under the stated conditions; higher temperatures shorten working time.
Typical material consumption is approximately 1.57 kg/m² for each millimetre of thickness. The nominal floor thickness is approximately 2 mm, with the system instructions allowing application at 2–3 mm. Follow the specified system thickness and allow separately for primer, scratch coat and finishing sealer. Light colours require at least 2 mm thickness for adequate opacity.
